Table of Contents
Advertisement
Configuring RIP
Command
Step 4
network network number
Step 5
neighbor ip-address
Step 6
offset list [access-list number | name]
{in | out} offset [type number]
Step 7
timers basic update invalid holddown
flush
Step 8
version {1 | 2}
Step 9
no auto summary
Step 10
no validate-update-source
Step 11
output-delay delay
Step 12
end
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
38-22
Purpose
Associate a network with a RIP routing process. You can specify multiple
network commands. RIP routing updates are sent and received through
interfaces only on these networks.
You must configure a network number for RIP commands to take
Note
effect.
(Optional) Define a neighboring router with which to exchange routing
information. This step allows routing updates from RIP (normally a
broadcast protocol) to reach nonbroadcast networks.
(Optional) Apply an offset list to routing metrics to increase incoming
and outgoing metrics to routes learned through RIP. You can limit the
offset list with an access list or an interface.
(Optional) Adjust routing protocol timers. Valid ranges for all timers are
0 to 4294967295 seconds.
update—The time between sending routing updates. The default is
•
30 seconds.
invalid—The time after which a route is declared invalid. The default
•
is 180 seconds.
holddown—The time until a route is removed from the routing table.
•
The default is 180 seconds.
flush—The amount of time for which routing updates are postponed.
•
The default is 240 seconds.
(Optional) Configure the switch to receive and send only RIP Version 1
or RIP Version 2 packets. By default, the switch receives Version 1 and
Version 2 but sends only Version 1.
You can also use the interface commands ip rip {send | receive} version
1 | 2 | 1 2} to control what versions are used for sending and receiving on
interfaces.
(Optional) Disable automatic summarization. By default, the switch
summarizes subprefixes when crossing classful network boundaries.
Disable summarization (only RIP Version 2) to advertise subnet and host
routing information to classful network boundaries.
(Optional) Disable validation of the source IP address of incoming RIP
routing updates. By default, the switch validates the source IP address of
incoming RIP routing updates and discards the update if the source
address is not valid. Under normal circumstances, we do not recommend
that you disable this feature. However, if you have a router that is
off-network and you want to receive its updates, you can use this
command.
(Optional) Add interpacket delay for RIP updates sent.
By default, packets in a multiple-packet RIP update have no delay time
added between packets. If you are sending packets to a lower-speed
device, you can add an interpacket delay in the range of 8 to
50 milliseconds.
Return to privileged EXEC mode.
Chapter 38
Configuring IP Unicast Routing
OL-12247-04
Advertisement
Chapters
Table of Contents
Troubleshooting
