Table of Contents
Advertisement
Configuring LLDP, LLDP-MED, and Wired Location Service
•
•
•
•
When the switch shuts down, it sends an attachment notification with the state delete and the IP address
before closing the NMSP connection to the MSE. The MSE interprets this notification as disassociation
for all the wired clients associated with the switch.
If you change a location address on the switch, the switch sends an NMSP location notification message
that identifies the affected ports and the changed address information.
Configuring LLDP, LLDP-MED, and Wired Location Service
•
•
•
•
•
•
•
Default LLDP Configuration
Table 29-1
Feature
LLDP global state
LLDP holdtime (before discarding)
LLDP timer (packet update frequency)
LLDP reinitialization delay
LLDP tlv-select
LLDP interface state
LLDP receive
LLDP transmit
LLDP med-tlv-select
Configuration Guidelines
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
29-4
Device category is specified as a wired station
State is specified as delete
Serial number, UDI
Time in seconds since the switch detected the disassociation
Default LLDP Configuration, page 29-4
Configuration Guidelines, page 29-4
Enabling LLDP, page 29-5
Configuring LLDP Characteristics, page 29-5
Configuring LLDP-MED TLVs, page 29-6
Configuring Network-Policy TLV, page 29-7
Configuring Location TLV and Wired Location Service, page 29-9
Default LLDP Configuration
If the interface is configured as a tunnel port, LLDP is automatically disabled.
Chapter 29
Configuring LLDP, LLDP-MED, and Wired Location Service
Default Setting
Disabled
120 seconds
30 seconds
2 seconds
Disabled to send and receive all TLVs
Disabled
Disabled
Disabled
Disabled to send all LLDP-MED TLVs
OL-12247-04
Advertisement
Chapters
Table of Contents
Troubleshooting
