Table of Contents
Advertisement
Configuring UDLD
Default UDLD Configuration
Table 28-1
Table 28-1
Default UDLD Configuration
Feature
UDLD global enable state
UDLD per-port enable state for fiber-optic media
UDLD per-port enable state for twisted-pair (copper) media
UDLD aggressive mode
Configuration Guidelines
These are the UDLD configuration guidelines:
•
•
•
Loop guard works only on point-to-point links. We recommend that each end of the link has a directly
Caution
connected device that is running STP.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
28-4
shows the default UDLD configuration.
UDLD is not supported on ATM ports.
A UDLD-capable port cannot detect a unidirectional link if it is connected to a UDLD-incapable
port of another switch.
When configuring the mode (normal or aggressive), make sure that the same mode is configured on
both sides of the link.
Default Setting
Globally disabled
Disabled on all Ethernet fiber-optic ports
Disabled on all Ethernet 10/100 and 1000BASE-TX ports
Disabled
Chapter 28
Configuring UDLD
OL-12247-04
Advertisement
Chapters
Table of Contents
Troubleshooting
