Table of Contents
Advertisement
Chapter 3
Cisco RFGW-10 UEQAM Installation
Figure 3-4
Chassis
installation
bracket
Note
After the chassis is installed and secured to the rack, the chassis installation brackets can be removed
from the rack. The brackets are not needed for supporting the chassis when all the rack-mount screws
are installed.
Installing the Chassis Installation Handles
This section explains how to attach the chassis installation handles to the chassis.
Before installing the chassis in the rack, it is recommended that you install a chassis lifting handle to
each side of the chassis to aid in lifting the chassis onto the rack.
Note
It is recommended to install the two side chassis installation handles while unpacking to aid in moving
the chassis off the palette.
The parts and tools required for installing the chassis installation handles are listed in the
Equipment" section on page
OL-16264-04
Chassis Installation Bracket
2-19.
Installing the Chassis Installation Handles
Cisco RF Gateway 10 Hardware Installation Guide
"Tools and
3-7
Advertisement
Table of Contents
