Table of Contents
Advertisement
Cisco RFGW-10 Components
Figure 1-16
The RF Switch Card supports the following features:
•
•
•
•
•
•
•
•
•
Table 1-13
Status LEDs
LED
POWER
Cisco RF Gateway 10 Hardware Installation Guide
1-28
RF Switch Card
10 RF bi-directional RF ports per RF Switch card
–
System support for 12 RF Switch cards, 120 RF Ports per chassis
–
Wire once interface: Coax cables are independent of the RF card insertion and removal
OIR (Hot Swap) and field upgradeability
Supports SW field upgrades
Exceeds DOCSIS DRFI compliance requirements over 5 MHz to 1.2 GHz frequency range
No active gain in any switch path
Support for Cisco UCH2 Dense (MCX) connector
Upto two flexible redundancy groups, each capable of N:1
LED to indicate RF Switch's active or fail mode
CLI support for configuring and monitoring the status information
Color/Status
Blank
Green
Blinking Green
Chapter 1
Description
RF Switch is not powered or Severe
firmware corruption
Normal operating conditions
Severe error condition (possibly power
out of specification or firmware
corruption)
Overview
OL-16264-04
Advertisement
Table of Contents
