Table of Contents
Advertisement
Installation and Removal of the Line Cards
To install a DS-48 line card in a Cisco RFGW-10 UEQAM chassis, do the following:
Step 1
Take the necessary precautions to prevent ESD damage as described in
Installation
Step 2
Ensure that you have enough clearance to accommodate any interface equipment that you will connect
directly to the Supervisor Card ports.
Step 3
Loosen the captive installation screws that secure the line card blank panel or the existing DS-48 line
card (whichever is present).
Step 4
Remove the line card blank panel or the existing DS-48 line card from the appropriate RF capable slot
as shown in
existing DS-48 line card, follow the instructions in
page
5-26.
Figure 5-13
1
10 DS-48 line cards (RF slots 3 through 12)
Step 5
To install a DS-48 line card, turn the module sideways with the board facing right, grasp the DS-48
module front panel with one hand and place your other hand under the board's side edge to support the
line card as shown in
Cisco RF Gateway 10 Hardware Installation Guide
5-24
chapter.
Figure
5-13. If a blank panel is installed, keep it for future use. If you are removing an
DS-48 Line Cards (RF Slots 3 through 12) Locations in the Cisco RFGW-10 Chassis
Figure
5-14. Do not touch the printed circuit boards or the connector pins.
Chapter 5
Installing and Removing FRUs
Preparing Your Site for
"Removing the DS-48 Line Card" section on
1
OL-16264-04
Advertisement
Table of Contents
