Table of Contents
Advertisement
Connecting Power and Ground
Note
Figure 124: Connecting Office Power — DC Power Modules (ANSI Only)
Caution
Caution
Step 13 Return to your originating procedure (NTP).
DLP-L20 Connecting Office Power (DC) to the NCS 2006 Shelf (ETSI Only)
Purpose
Use only pressure terminal connectors, such as ring and fork types, when terminating the battery,
battery return, and frame ground conductors.
Before you make any crimp connections, coat all bare conductors (battery, battery return, and
frame ground) with an appropriate antioxidant compound. Bring all unplated connectors, braided
strap, and bus bars to a bright finish, then coat with an antioxidant before you connect them. You
do not need to prepare tinned, solder-plated, or silver-plated connectors and other plated connection
surfaces, but always keep them clean and free of contaminants.
When terminating power, return (RET), and frame ground, do not use soldering lug, screwless
(push-in) connectors, quick-connect, or other friction-fit connectors.
DLP-L20 Connecting Office Power (DC) to the NCS 2006 Shelf (ETSI Only)
This task connects power to the NCS 2006 shelf
(ETSI Only).
Cisco NCS 2000 Series Hardware Installation Guide
213
- Quick Links:
- Cisco Ncs 2006 Shelf
- Ncs 2006
Hide quick links:
Advertisement
Chapters
Table of Contents
