Table of Contents
Advertisement
VPN
Netmask
Multicast forwarding
Aggressive Mode
Step 3
Click Apply.
Client to Site
Clients from the Internet can connect to the server to access the corporate network or a LAN behind the server.
This feature creates a new VPN tunnel to allow teleworkers and business travelers to access your network by
using third-party VPN client software.
To configure the Client-to-Site, follow these steps:
Step 1
Click VPN > Client-to-Site.
Step 2
Click Add and the IPsec Client-to-Site Groups table will be displayed.
Step 3
To add a Client to Site connection, click Add.
Step 4
In the Add a New Group section, select an option (Cisco VPN Client or 3rd Party Client).
Step 5
For Cisco VPN Client, configure the following:
Enable
Group Name
Interface
Enter the netmask.
Select Multicast forwarding to allow the router forward multicast traffic to networks
where other multicast devices are receptive. Multicast forwarding prevents the forwarding
of multicast traffic to networks where there are receptive no nodes. Click the link to
configure the IGMP proxy interface.
Click to enable aggressive mode.
Click Enable to enable the configuration.
Enter a group name. This is used as an identifier for all the members of this group during
IKE negotiations.
Select the interface (WAN1, WAN2, USB1, or USB2) from the drop-down list.
Client to Site
RV345/345P Administration Guide
85
- Quick Links:
- Getting Started
- Wan Settings
Hide quick links:
Advertisement
Table of Contents
