Table of Contents
Advertisement
WAN Settings
DNS Server
Static DNS 1 & 2
DHCP-PD (IPv6 only)
When the IPv4 or IPv6 connection uses Static IP
In the Static IP Settings, enter the following information:
WAN IP Address
Netmask
Default Gateway
Static DNS 1 & 2
DHCP-PD (IPv6 only)
When the IPv4 or IPv6 connection uses PPPoE
In the PPPoE Settings section, enter the following information:
Username
Password
DNS Server
Static DNS 1 & 2
Connect Mode
Authentication Type
Service Name
DHCP-PD (IPv6 only)
Some service providers do not allow to ping the default gateway, especially for the PPPoE connection. Please
Note
go to Multi-WAN page to disable the "Network Service Detection" feature or choose a valid host to detect.
Otherwise, the traffic will not be forwarded by the device.
When the IPv4 connection is through PPTP
In the PPTP section, enter the following:
RV345/345P Administration Guide
38
Select Use DHCP Provided DNS Server or Use DNS as Below.
Enter the IP address of the primary and or secondary Static DNS in the fields.
Check to enable and enter a prefix name.
Enter the IP address.
Enter the netmask.
Enter the IP address of the default gateway. Default Gateway is needed on this interface
to participate in the load balance and failover (Multi-WAN).
Enter the IP address of the primary and or secondary Static DNS in the fields.
Check to enable and enter a prefix name.
The username assigned to you by the ISP.
The password assigned to you by the ISP.
Select Use PPPoE Provided DNS Server or Use DNS.
Enter the IP address of the primary and or secondary Static DNS in the fields.
Select Connect on Demand if your ISP charges when connected. Enter the maximum
idle time, in seconds, to wait before terminating the connection due to inactivity. Default
is 5 minutes.
Select Keep Alive to periodically check the connection, and to re-establish the connection
when it is disconnected.
Select the authentication type from the drop-down list (Auto, PAP, CHAP, MS-CHAP,
MS-CHAPv2).
Enter the name of the service.
Check to enable and enter a prefix name.
WAN
- Quick Links:
- Getting Started
- Wan Settings
Hide quick links:
Advertisement
Table of Contents
