Table of Contents
Advertisement
Port Triggering
Step 5
Click Apply.
The port forwarding rules for UPnP are dynamically added by the UPnP application.
Note
Step 6
In the UPnP Port Forwarding Table, click Refresh to refresh the UPnP listing.
Port Triggering
Port triggering allows a specified port or port range to open for inbound traffic after user sends outbound
traffic through the trigger port. Port triggering allows the device to monitor outgoing data for specific port
numbers. The device recalls the client's IP address that sent the matching data. When the requested data returns
through the device, the data is sent to the proper client using the IP addressing and port mapping rules.
To add or edit a service to the port triggering table, configure the following:
Step 1
Click Add (or select the row and click Edit) and enter the information:
Application Name
Trigger Service
Incoming Service
Interfaces
Status
Step 2
Click Service Management, to add or edit an entry on the Service list.
Step 3
In the Service Table, click Add or Edit and configure the following:
• Application Name — Name of the service or application.
• Protocol — Required protocol. Refer to the documentation for the service that you are hosting.
• Port Start/ICMP Type/IP Protocol — Range of port numbers reserved for this service.
• Port End — Last number of the port, reserved for this service.
Step 4
Click Apply.
RV345/345P Administration Guide
72
Enter the name of the application.
Select a service from the drop-down list. (If a service is not listed, you can add or modify
the list by following the instructions in the Service Management section.)
Select a service from the drop-down list. (If a service is not listed, you can add or modify
the list by following the instructions in the Service Management section.)
Select the interface from the drop-down list.
Enable or disable the port triggering rule.
Firewall
- Quick Links:
- Getting Started
- Wan Settings
Hide quick links:
Advertisement
Table of Contents
