Tilting Up And Down; Procedure For Tilting Up (Manual Tilt Models) - Yamaha 6C Owner's Manual
Hide thumbs
Also See for 6C:
- Owner's manual (64 pages) ,
- Owner's manual (64 pages) ,
- Owner's manual (186 pages)
Table of Contents
Advertisement
Operation
the bow is greatly increased, heightening the
danger of "bow steering" and making opera-
tion difficult and dangerous.
TIP:
Depending on the type of boat, the outboard
motor trim angle may have little effect on the
trim of the boat when operating.
EMU27935
Tilting up and down
If the engine will be stopped for some time or
if the boat is moored in shallows, the out-
board motor should be tilted up to protect the
propeller and lower casing from damage by
collision with obstructions, and also to re-
duce salt corrosion.
EWM00222
WARNING
Make sure that no one is near the out-
board motor when tilting the outboard
motor up or down. Otherwise, body parts
could be crushed between the outboard
motor and the clamp bracket.
EWM00250
WARNING
Leaking fuel is a fire hazard. If there is a
fuel joint on the outboard motor, discon-
nect the fuel line or close the fuel cock if
the engine will be tilted for more than a
few minutes. Otherwise fuel may leak.
33
ECM00241
NOTICE
Before tilting the outboard motor, stop
the engine by following the procedure
on page 30. Never tilt the outboard mo-
tor while the engine is running. Severe
damage from overheating can result.
Do not tilt up the engine by pushing the
tiller handle (if equipped) because this
could break the handle.
EMU32662
Procedure for tilting up (manual tilt
models)
1.
Place the gear shift lever in neutral.
2.
Disconnect the fuel line from the out-
board motor.
3.
Place the tilt lock lever (if equipped) in
the release/up position.
4.
Pull up the shallow water lever (if
equipped).
Advertisement
Table of Contents
