Removing Propeller; Installing Propeller; Changing Gear Oil - Yamaha 6C Owner's Manual
Hide thumbs
Also See for 6C:
- Owner's manual (64 pages) ,
- Owner's manual (64 pages) ,
- Owner's manual (186 pages)
Table of Contents
Advertisement
Maintenance
Check the propeller shaft oil seal for dam-
age.
EMU30662
Removing propeller
EMU29197
Spline models
1.
Straighten the cotter pin and pull it out
using a pair of pliers.
2.
Remove the propeller nut, washer, and
spacer (if equipped). WARNING! Do
not use your hand to hold the propel-
ler when loosening the propeller nut.
[EWM01890]
1. Cotter pin
2. Propeller nut
3. Washer
4. Propeller
5. Thrust washer
3.
Remove
the
equipped), and thrust washer.
EMU30672
Installing propeller
EMU29234
Spline models
ECM00501
NOTICE
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
1.
Apply Yamaha marine grease or a corro-
45
1
2
3
4
5
ZMU02877
propeller,
washer
sion resistant grease to the propeller
shaft.
2.
Install the spacer (if equipped), thrust
washer, washer (if equipped), and pro-
peller on the propeller shaft. NOTICE:
Make sure to install the thrust washer
before installing the propeller. Other-
wise, the lower case and propeller
boss could be damaged.
3.
Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
Propeller nut tightening torque:
17.0 Nm (1.73 kgf-m, 12.5 ft-lb)
4.
Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTICE: Do not reuse the cotter pin.
Otherwise, the propeller can come off
during operation.
(if
TIP:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, tighten the nut further to
align it with the hole.
EMU29289
Changing gear oil
EWM00800
WARNING
Be sure the outboard motor is securely
[ECM01881]
[ECM01891]
ZMU02063
Advertisement
Table of Contents
