Checks After Engine Warm Up; Shifting; Stop Switches - Yamaha 6C Owner's Manual
Hide thumbs
Also See for 6C:
- Owner's manual (64 pages) ,
- Owner's manual (64 pages) ,
- Owner's manual (186 pages)
Table of Contents
Advertisement
Operation
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36971
Stop switches
Perform the following procedure to check
that the engine stop switch and engine shut-
off switch operate properly.
Start the engine, and then check that the
engine stops when the engine stop button
is pushed.
Restart the engine, and then check that
the engine stops when the clip is pulled
from the engine shut-off switch.
Check that the engine cannot be started
with the clip removed from the engine
shut-off switch.
EMU34550
Shifting
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1.
Move the gear shift lever firmly and
crisply forward (for forward gear) or
29
backward (for reverse gear). Be sure to
check that the tilt lock lever is in the
lock/down position (if equipped) before
operating in reverse.
N
R
To shift from in gear (forward/reverse) to
neutral
1.
Close the throttle so that the engine
slows to idle speed.
2.
After the engine is at idle speed in gear
move the gear shift lever firmly and
crisply into the neutral position.
F
ZMU05921
ZMU02030
Advertisement
Table of Contents
