Brother DCP-110C Quick Setup Manual page 8
Hide thumbs
Also See for DCP-110C:
- Software user's manual (175 pages) ,
- User manual (107 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
Step 1
4
Take out the ink cartridge.
5
Carefully remove the buttom cap.
DO NOT touch the area shown in the
illustration below.
Opening
If the cartridge cover comes off when you
open the bag the cartridge will not be
damaged.
Keep the ink cartridge in an upright position
when you insert it into the slot.
OK
OK
OK
6
Setting Up the Machine
6
Press firmly down on the ink cartridge until
the hook snaps over it, taking care to match
the slot colour (A) with the cartridge colour
(B), as shown in the diagram below.
(A)
OK
OK
OK
7
Lift the scanner cover to release the lock.
Gently push the scanner cover support
down and close the scanner cover.
If
shows on the LCD after you
Install
install the ink cartridges, check to make sure
the ink cartridges are installed correctly.
The machine will clean the ink tube system
for use for the first time. This process will
occur only once, the first time ink cartridges
are installed. The cleaning process will last
approximately four minutes.
The LCD shows:
Preparing System
Approx 4 Minutes
(B)
Advertisement
Chapters
Table of Contents
