Step 1; Setting Up The Machine; Removing The Protective Parts; Attaching The Control Panel - Brother DCP-110C Quick Setup Manual
Hide thumbs
Also See for DCP-110C:
- Software user's manual (175 pages) ,
- User manual (107 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
Step 1
Removing the Protective
1
Parts
1
Remove the protective tape.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.
Attaching the Control
2
Panel
1
Attach the control panel to the machine.
Loading Paper
3
You can load up to 100 sheets of 80 g/m
paper.
For more details, see "About paper" in
Chapter 1 of the User's Guide.
1
Pull the paper tray completely out of the
machine and remove the output paper tray.
4
Setting Up the Machine
2
Press and slide the paper guide to fit the
paper width.
Paper Side Guide
3
Pull out the paper support and unfold the
paper support flap.
Paper Support Flap
Use the paper support flap for Letter, Legal
and A4 size paper.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
5
Gently insert the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray and
2
below the maximum paper mark.
■ Make sure the paper side guides touch
the sides of the paper.
■ Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
6
Put the output paper tray back on and push
the paper tray firmly back into the machine.
Paper Support
Advertisement
Chapters
Table of Contents
