Table of Contents
Advertisement
2.6 Installing 5.25-inch drives
Make sure to unplug the power cable before installing or removing any
system components. Failure to do so may cause severe damage to the
motherboard and other system components!
The system comes with four 5.25-inch
drive bays located on the upper front
part of the chassis. An optical drive
that comes standard/optional with
the system package occupies the
uppermost bay (labeled 1). The lower
bays (labeled 2, 3, and 4) are available
for additional 5.25‑inch optical, zip, or
floppy disk drives.
You must remove the front
panel cover before installing a
5.25-inch drive(s).
2.6.1 Removing the front panel cover
To remove the front panel cover:
1. Locate and remove two screws
that secure the left side cover
to the chassis. Keep the screw
for later use.
ASUS TS100-E4/PI2
1
2
2. Slightly pull the cover toward
the direction of the rear panel
until it disengages from the
chassis. Set the cover aside.
1
2
3
4
2-15
Advertisement
Table of Contents
