Dell S4810 Reference Manual page 162

Hide thumbs Also See for S4810:

Table of Contents

ipv4-address

ipv6-address

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.0.0.0

Version 8.1.1.0

Version 7.5.1.0

You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only

one of each. Each time this command is issued, it replaces the previously

configured address of the same family, IPv4 or IPv6. The no virtual-ip

command takes an address/prefix-length argument, so that the desired address

only is removed. If you enter the no virtual-ip command without any specified

address, then both IPv4 and IPv6 virtual addresses are removed.

Enter the IP address of the active management interface in a

dotted decimal format (A.B.C.D.).

Enter an IPv6 address of the active management interface, in

the x:x:x:x::x format.

NOTE: The :: notation specifies successive hexadecimal

fields of zeros.

Introduced on the S6000.

Introduced on the Z9000

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the C-Series.

Original command.

— assigns a primary and secondary IP address to the interface.

Control and Monitoring

Show Quick Links

Table of Contents