Ip Igmp Version - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

implicitly assumes all sources are included. If you do not specify either include or

exclude, Dell Networking OS implicitly assumes a IGMPv2 static join.

Command Limitations

show ip igmp groups

ip igmp version

Manually set the version of the router to IGMPv2 or IGMPv3.

ip igmp version {2 | 3}

2 (that is, IGMPv2)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.2(0.0)

Version 8.3.11.1

Version 8.3.7.0

Version 7.8.1.0

Version 7.7.1.0

Only one mode (include or exclude) is permitted per multicast group per

interface. To configure another mode, all sources belonging to the original

mode must be unconfigured.

If a static configuration is present and a packet for the same group arrives on an

interface, the dynamic entry completely overwrites all the static configuration

for the group.

— displays IGMP group information.

Enter the number 2 to set the IGMP version number to

Enter the number 3 to set the IGMP version number to

Introduced on the S6000.

Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Internet Group Management Protocol (IGMP)