Ip Igmp Query-Interval - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

ip igmp query-interval

Change the transmission frequency of IGMP general queries the Querier sends.

ip igmp query-interval seconds

To return to the default values, use the no ip igmp query-interval

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.2(0.0)

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Version 7.8.1.0

Version 7.7.1.0

Version 7.6.1.0

Version 7.5.1.0

E-Series legacy

Enter the number of seconds between queries sent out. The

range is from 1 to 18000. The default is 60 seconds.

Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the S-Series in Interface VLAN mode only to

enable the system to act as an IGMP Proxy Querier.

Introduced on the C-Series in Interface VLAN mode only to

enable the system to act as an IGMP Proxy Querier.

Internet Group Management Protocol (IGMP)