Entering The Initial Configuration Information; Ip Settings; Completing The Setup Program - Cisco Catalyst 3750 Hardware Installation Manual
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
Entering the Initial Configuration Information
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch
is powered up. You must assign an IP address and other configuration information necessary for the
switch to communicate with the local routers and the Internet. This information is also required if you
plan to use the Network Assistant to configure and manage the switch.
IP Settings
You will need this information from your network administrator before you complete the setup program:
•
•
•
•
•
•
Completing the Setup Program
If your switches are stacked and there are multiple console connections to individual switches in the
Note
stack, the initial setup dialog appears in the first console where the user presses Enter.
Follow these steps to complete the setup program and to create an initial configuration for the switch:
Step 1
Enter Yes at the following two prompts.
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Enter a host name for the switch, and press Return.
Step 2
On a command switch, the host name is limited to 28 characters; on a member switch to 31 characters.
Do not use -n, where n is a number, as the last character in a host name for any switch.
Enter host name [Switch]: host_name
Catalyst 3750 Switch Hardware Installation Guide
D-8
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Appendix D
Configuring the Switch with the CLI-Based Setup Program
OL-6336-06
Advertisement
Chapters
Table of Contents
