Cisco Catalyst 3750 Hardware Installation Manual page 143
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
Appendix D
Configuring the Switch with the CLI-Based Setup Program
Enter an enable secret password, and press Return.
Step 3
The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive,
allows spaces, but ignores leading spaces. The secret password is encrypted and the enable password is
in plain text.
Enter enable secret: secret_password
Enter an enable password, and press Return.
Step 4
Enter enable password: enable_password
Enter a virtual terminal (Telnet) password, and press Return.
Step 5
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores
leading spaces.
Enter virtual terminal password: terminal-password
(Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts.
Step 6
You can also configure SNMP later through the CLI, the device manager, or the Network Assistant
application. To configure SNMP later type no.
Configure SNMP Network Management? [no]: no
Enter the interface name (physical interface or VLAN name) of the interface that connects to the
Step 7
management network, and press Return. For this release, always use vlan1 as that interface.
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configure the interface by entering the switch IP address and subnet mask and pressing Return. The IP
Step 8
address and subnet masks shown below are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member
Step 9
switch or as a standalone switch.
If you enter N, the switch appears as a candidate switch in the Network Assistant GUI. You can configure
the switch as a command switch later through the CLI, the device manager, or the Network Assistant
application. To configure it later, enter no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch and the switch displays its initial
configuration. This is an example of output that appears:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
OL-6336-06
Entering the Initial Configuration Information
Catalyst 3750 Switch Hardware Installation Guide
D-9
Advertisement
Chapters
Table of Contents
