Cisco Catalyst 3750 Hardware Installation Manual page 144

Hide thumbs Also See for Catalyst 3750:

Table of Contents

Entering the Initial Configuration Information

interface FastEthernet1/0/1

interface FastEthernet1/0/2

interface FastEthernet1/0/3

...<output abbreviated>

interface GigabitEthernet2/0/28

end

These choices are displayed:

Step 10

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots, save it in nonvolatile

RAM (NVRAM) by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

After you complete the setup program, the switch can run the default configuration that you created. If

you want to change this configuration or want to perform other management tasks, use one of these tools:

Command-line interface (CLI)

•

Network Assistant (for one or more switches)

•

To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal

program or through the network by using telnet. For configuration information, see the switch software

configuration guide or the switch command reference.

To use the Network Assistant, see the Getting Started with Cisco Network Assistant guide on Cisco.com.

Catalyst 3750 Switch Hardware Installation Guide

D-10

Appendix D

Configuring the Switch with the CLI-Based Setup Program

OL-6336-06

Table of Contents

Chapters

Table of Contents