Uninstalling The Cisco Microsoft Windows Vista And Windows 7 Usb Driver; Entering The Initial Configuration Information - Cisco Catalyst 2360 Hardware Installation Manual
Hide thumbs
Also See for Catalyst 2360:
- Getting started manual (21 pages) ,
- Software configuration manual (554 pages)
Table of Contents
Advertisement
Entering the Initial Configuration Information
Choose Start > Control Panel > Add or Remove Programs.
Step 2
Scroll to Cisco Virtual Com and click Remove.
Step 3
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 4
Using the Setup.exe Program
Disconnect the console terminal or PC from the switch.
Step 1
Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 2
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 3
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 4
Step 5
When the Remove the Program window appears, click Remove.
Step 6
When the InstallShield Wizard Completed window appears, click Finish.
Uninstalling the Cisco Microsoft Windows Vista and Windows 7 USB Driver
Disconnect the console terminal or PC from the switch.
Step 1
Step 2
Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 3
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 4
When the Program Maintenance window appears, select the Remove radio button. Click Next.
When the Remove the Program window appears, click Remove.
Step 5
If a User Account Control warning appears, click Allow - I trust this program to proceed.
Note
When the InstallShield Wizard Completed window appears, click Finish.
Step 6
Entering the Initial Configuration Information
You need to complete the setup program that runs after the switch powers on. You must assign an IP
address and other configuration information necessary for the switch to communicate with the local
routers and the Internet. This information is also needed to use the device manager or Cisco Network
Assistant to configure and manage the switch.
IP Settings
You need this information:
•
•
Catalyst 2360 Switch Hardware Installation Guide
C-6
Switch IP address
Subnet mask (IP netmask)
Appendix C
Configuring the Switch with the CLI-Based Setup Program
OL-22150-02
Advertisement
Table of Contents
