Table of Contents
Advertisement
13. Use the arrow keys to select Exit Utility from the menu or press Esc to exit
from the program.
14. Remove the CD from the server.
If you also want to configure the serial port, continue with "Configuring the serial
port for text-based remote access." Otherwise, go to "Installing Advanced System
Management device drivers" on page 28.
Configuring the serial port for text-based remote access: Complete the
following steps to configure the Remote Supervisor Adapter serial port for access
using a modem or null modem. If you completed the procedure for configuring the
Ethernet port and the Configuration Settings window is open, go to step 6..
1. Insert the CD containing the EFI Remote Supervisor Utility program into the
drive; then, turn on the server.
2. Select EFI Shell from the EFI Firmware Boot Manager.
Note: If EFI shell is not a choice in the list, the server has a customized
startup configuration. Contact your system administrator for instructions.
3. Change to the file system for the formatted media and the directory where the
program is located.
4. Type the following EFI command:
flash2
5. Use the Up Arrow and Down Arrow keys (— and –) to select Configuration
Settings; then, press Enter.
The Configuration Settings window opens.
6. Use the arrow keys to select Modem Settings; then, press Enter.
The Modem Settings window opens, as shown in the following illustration.
Note: The settings in the window are only examples; your settings might be
different.
Chapter 2. Configuring the server
25
Advertisement
Table of Contents
Troubleshooting
