Cisco RV215W Administration Manual page 56
Wireless-n vpn firewall
Hide thumbs
Also See for RV215W:
- Administration manual (140 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
Configuring Networking
Configuring IPv6
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Authentication Type
Service Name
MTU
Size
Address Mode
IPv6 Prefix Length
Default IPv6 Gateway
Static DNS 1
Static DNS 2
Authentication types:
Auto-negotiation—A server sends a configuration
request specifying the security algorithm set on
the server. The device replies with its
authentication credentials, including the security
type sent by the server.
PAP—Use the Password Authentication Protocol
(PAP) to connect to the ISP.
CHAP—Use Challenge Handshake Authentication
Protocol (CHAP) to connect with the ISP.
MS-CHAP or MS-CHAPv2—Use Microsoft
Challenge Handshake Authentication Protocol to
connect to the ISP.
Name that your ISP might require to log onto the
PPPoE server.
The maximum transmission unit (MTU) or the size of
the largest packet that can be sent over the
network.
Unless a change is required by your ISP, we
recommend that you choose Auto. The standard
MTU value for Ethernet networks is 1500 bytes. For
PPPoE connections, the value is 1492 bytes. If your
ISP requires a custom MTU setting, choose
Manual.
MTU size. If your ISP requires a custom MTU
setting, enter the MTU size.
Dynamic or static address mode. If you choose
static, enter the IPv6 address in the next field.
IPv6 prefix length.
IP address of the default IPv6 gateway.
IP address of the primary DNS server.
IP address of the secondary DNS server.
6
56
- Quick Links:
- Verifying the Hardware Installation
Hide quick links:
Advertisement
Table of Contents
