Good Working Practices; Disassembly And Assembly; Identification; Applicable Models - Yamaha F50F Service Manual
Hide thumbs
Also See for F50F:
- Owner's manual (110 pages) ,
- Service manual (11 pages) ,
- Owner's manual (96 pages)
Table of Contents
Advertisement
6. Keep a supply of clean, lint-free cloths for
wiping up spills, etc.
Good working practices
Special service tools
Use the recommended special service tools
to protect parts from damage. Use the right
tool in the right manner—do not improvise.
Tightening torques
Follow the tightening torque specifications
provided throughout the manual. When tight-
ening nuts, bolts, and screws, tighten the
large sizes first, and tighten fasteners starting
in the center and moving outward.
Non-reusable parts
Always use new gaskets, seals, O-rings, cot-
ter pins, circlips, etc., when installing or
assembling parts.
Disassembly and assembly
1. Use compressed air to remove dust and
dirt during disassembly.
2. Apply engine oil to the contact surfaces
of moving parts before assembly.
6C13G11
Safety while working / Identification
3. Install bearings with the manufacture
identification mark in the direction indi-
cated in the installation procedure. In
addition, be sure to lubricate the bearings
liberally.
4. Apply a thin coat of water-resistant
grease to the lip and periphery of an oil
seal before installation.
5. Check that moving parts operate nor-
mally after assembly.
Identification
Applicable models
This manual covers the following models.
Applicable models
F50FED, F50FEHT, F50FET, FT50GET,
F60CEHT, F60CET, FT60DET
(*)
Hydro tilt model (For Europe)
(*)
Tiller handle model (For Oceania)
1
2
3
4
5
1
6
7
8
9
1-4
Advertisement
Chapters
Table of Contents
