Table of Contents
Advertisement
Using the Cisco MGCP IP Phone with a Catalyst Switch
•
•
•
•
•
Note
Only the network port (labeled 10/100 SW) supports inline power from the Cisco Catalyst switches.
For redundancy, you can use the Cisco AC adapter even if you are using inline power from the
Cisco Catalyst switches. The Cisco MGCP IP phone can share the power load being used from the inline
power and external power source. If either the inline power or the external power goes down, the phone
can switch entirely to the other power source.
To use this redundancy feature you must set the inline power mode to auto on the Cisco Catalyst switch.
Next, connect the un-powered Cisco MGCP IP phone to the network. After the phone powers up, connect
the external power supply to the phone.
Using a Headset
The Cisco IP Phone 7960 supports a four or six-wire headset jack. Specifically, the Cisco MGCP IP
phone supports the following Plantronics headset models:
•
•
•
The Volume and Mute controls will also adjust volume to the earpiece and mute the speech path of the
headset. The headset activation key is located on the front of the Cisco MGCP IP phone.
Note
When using a headset, an amplifier is not required. However, a coil cord is required to connect the
headset to the headset port on the back of your Cisco IP Phone 7940/7960. For information on ordering
compatible headsets and coil cords for the Cisco IP phone 7940/7960, see
or http://vxicorp.com/cisco.
Using the Cisco MGCP IP Phone with a Catalyst Switch
To function in the IP telephony network, the Cisco MGCP IP phone must be connected to a networking
device, such as a Catalyst switch, to obtain network connectivity.
The Cisco MGCP IP phone has an internal Ethernet switch, which enables it to switch traffic coming
from the phone, access port, and the network port.
Cisco MGCP IP Phone Administrator Guide, Release 5.0 and Release 5.1
2-4
WS-PWR-PANEL—Power patch panel provides power to the Cisco MGCP IP phone which allows
the Cisco MGCP IP phone to be connected to existing Catalyst 4000, 5000, and 6000 family
10/100BASE-TX switching modules.
This module sends power on pins 4, 5, 7, and 8.
WS-X4148-RJ45V—48 port 10/100 Ethernet with inline power module for the Catalyst 4006.
WS-X4095-PEM—VoIP DC Power Entry module for the Catalyst 4006.
WS-X4608-2PSU and WS-X4608—External -48V DC power shelf common equipment for the
Catalyst 4006 with two AC-to-DC PSUs and one empty bay for redundant option and the 110V 15A
AC-to48V DC PSU redundant option for the power shelf
WS-C3524-PWR-XL-EN—Catalyst 3524-PWR XL switch
Tristar Monaural
Encore Monaural H91
Encore Binaural H101
Chapter 2
Installing the Cisco MGCP IP Phone
http://cisco.getheadsets.com
Advertisement
Table of Contents
