Resetting The Control Timers - Cisco 501G Administration Manual
Hide thumbs
Also See for 501G:
- User manual (93 pages) ,
- Administration manual (311 pages) ,
- Configuration manual (12 pages)
Table of Contents
Advertisement
Configuring Dial Plans
Resetting the Control Timers
STEP 9
STEP 10
NOTE
Resetting the Control Timers
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco SPA500 Series and WIP310 IP Phone Administration Guide
If you need to configure a dial plan for any other extensions on the phone
(depending on the model), click the appropriate Extension tab, enter the dial plan,
and submit the changes.
Verify that you can successfully complete a call using each digit sequence that
you entered in the dial plan.
If you hear a reorder (fast busy) tone, you need to review your entries and modify
the dial plan appropriately. See
You can use the following procedure to reset the default timer settings for all calls.
If you need to edit a timer setting only for a particular digit sequence or type of call,
you can edit the dial plan. See
Log in to the web administration interface.
Click Admin Login and advanced.
Click Voice tab > Regional.
Scroll down to the Control Timer Values section.
Enter the desired values in the Interdigit Long Timer field and the Interdigit Short
Timer field. Refer to the definitions at the beginning of this section.
"Digit Sequences," on page
"About Dial Plans," on page
8
152.
150.
161
Hide quick links:
Advertisement
Chapters
Table of Contents
