Management Ethernet Port Cable Connection - Cisco ASR 1002 Quick Start Manual
Asr 1002 router
Hide thumbs
Also See for ASR 1002:
- Hardware installation manual (57 pages) ,
- Software configuration manual (378 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Figure 8
Cisco ASR 1002 Integrated Route Processor Console and Auxiliary Port Connectors
1
CON—console port
After you establish normal router operation, you can disconnect the terminal.
Step 3
For console and auxiliary port pinouts, see Cisco ASR 1002 router specifications in the Cisco ASR 1000 Series
Note
Aggregation Services Routers Hardware Installation and Initial Configuration Guide.
Management Ethernet Port Cable Connection
Caution
To comply with Class A emissions requirements, a shielded Ethernet cable must be used.
To use the Management Ethernet interface on the router, perform the following steps:
Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see
Step 1
Figure 9
Cisco ASR 1002 Integrated Route Processor Ethernet Management Port Connector
MGMT port and cable
1
Step 2
Insert the other end of the RJ-45 cable to your management device or network.
12
MT S
CA RR IER
BO OT
QE 3
QE 2
QE 1
QE 0
ST AT
A S R 10 02
m in
st at
m aj
pw r
cr it
2
AUX—auxiliary port
MT S
CA RR IER
BO OT
QE 3
QE 2
QE 1
QE 0
ST AT
A S R 10 02
m in
st at
m aj
pw r
cr it
1
2
PW R ST AT
CO N
AU X
MG MT
LIN K
PO S
SP A-4 XO C3-
Figure
9).
1
PW R ST AT
CO N
AU X
MG MT
LIN K
PO S
SP A-4 XO C3-
Advertisement
Table of Contents
