Cisco Catalyst 3750 Command Reference Manual page 434
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
snmp-server enable traps
pim
invalid-pim-message
neighbor-change
rp-mapping-change
port-security
trap-rate value
rtr
snmp
authentication
coldstart
linkdown
linkup
warmstart
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
Though visible in the command-line help strings, the snmp-server enable informs command is not
Note
supported. To enable the sending of SNMP inform notifications, use the snmp-server enable traps
command combined with the snmp-server host host-addr informs command.
Defaults
The sending of SNMP traps is disabled.
Command Modes
Global configuration
Command History
Release
12.1(11)AX
12.1(14)EA1
12.2(18)SE
Catalyst 3750 Switch Command Reference
2-408
(Optional) Enable Protocol-Independent Multicast (PIM) traps.
(Optional) Enable invalid PIM message traps.
(Optional) Enable PIM neighbor-change traps.
(Optional) Enable rendezvous point (RP)-mapping change traps.
(Optional) Enable SNMP port security traps.
(Optional) Set the maximum number of port-security traps sent per second.
The range is from 0 to 1000; the default is 0 (no limit imposed; a trap is sent
at every occurrence).
(Optional) Enable SNMP Response Time Reporter traps.
(Optional) Enable SNMP traps.
(Optional) Enable authentication trap.
(Optional) Enable cold start trap.
(Optional) Enable linkdown trap.
(Optional) Enable linkup trap.
(Optional) Enable warmstart trap.
(Optional) Enable SNMP STPX MIB traps.
(Optional) Enable SNMP syslog traps.
(Optional) Send Transmission Control Protocol (TCP) connection traps. This
is enabled by default.
(Optional) Enable SNMP VLAN membership traps.
(Optional) Enable SNMP VLAN-created traps.
(Optional) Enable SNMP VLAN-deleted traps.
(Optional) Enable VLAN Trunking Protocol (VTP) traps.
Modification
This command was introduced.
The bgp, copy-config, envmon, flash, port-security, stpx, syslog,
vlancreate, and vlandelete keywords were added.
The ipmulticast, msdp, pim [invalid-pim-message | neighbor-change |
rp-mapping-change], and tty keywords were added.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
78-16181-01
- Quick Links:
- Boot System
Hide quick links:
Advertisement
Table of Contents
