hit counter script
Zanussi ZDW 946 S Instruction Booklet
Zanussi ZDW 946 S Instruction Booklet

Zanussi ZDW 946 S Instruction Booklet

Dishwasher zdw 946 s

Advertisement

Quick Links

INSTRUCTION BOOKLET
DISHWASHER
ZDW 946 S

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZDW 946 S

  • Page 1 INSTRUCTION BOOKLET DISHWASHER ZDW 946 S...
  • Page 2: Table Of Contents

    CONTENTS Warnings ...............page Installation .
  • Page 3: Warnings

    Care must be taken to ensure that the appliance does not stand on the electrical supply cable or on the water inlet and drain hoses. Zanussi dishwashers are designed to be used for washing normal household utensils. Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed in a dishwasher.
  • Page 4: Installation

    INSTALLATION Remove all packaging before positioning the Installing and securing the machine under a machine. kitchen unit (sink-worktop unit) Positioning By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, if If possible, position the machine next to a water tap the dimensions of the recess correspond to those and a drain.
  • Page 5 Water outlet connection The problem is signalled by a red or yellow indicator which appears in window (B - The end of the drain hose can be connected as If this happens, close the water tap and have the hose follows: replaced.
  • Page 6: Use

    Control panel 2 3 4 5 1. Pilot light 6. Door handle This comes on when the ON/OFF button (2) is To open the door press the catch in the top of the depressed, indicating that the machine is on. recess and pull the door toward you at the same time.
  • Page 7 Rinse aid Use of detergent This liquid gives the dishes a shiny finish and Before starting any of the dishwashing programmes, improves drying. It is automatically added during the except for the rinse and hold programme, load the hot rinse. The dispenser, which is positioned inside detergent in the dispenser.
  • Page 8 Loading your machine The cutlery basket is in two parts which can be Before placing dishes in the machine, remove any separated to give greater scraps of food from the plates (small bones, loading flexibility. To sepa- toothpicks, fish bones, scraps of meat and vegetables, rate the two parts, slide fruit skins etc.) to avoid clogging the filters and them horizontally in opposite...
  • Page 9: Adjusting The Height Of The Upper Basket

    Caution Adjusting the height of the upper basket To ensure proper water dis- If washing very large plates (over 27 cm and up to 31 tribution to the upper bas- cm in diameter) you can load them in the lower ket, do not place dishes basket after moving the upper basket to the higher over the hole in the SID...
  • Page 10: Washing Programmes

    WASHING PROGRAMMES Recommended Quantity of Detergent In the Cycle Programme Degree of soil Programme Required In the Super Intensity Description and type of Knob Pushbuttons dispenser Dispenser load Setting (SID) Heavy soil. Prewash up to 55°C Intensive Main wash up to 70°C Crockery, 70°c 70°c...
  • Page 11: Operating Sequence

    Operating Sequence 6 Select the temperature 1 Check that the filters are clean Select the temperature according to the instructions in the Washing Programmes chart (see "Required push (see cleaning instructions) When the button “70°c SID” is depressed, the prewash is at 55°C and the main wash at 65°C.
  • Page 12: Maintenance And Cleaning

    MAINTENANCE AND CLEANING Cleaning the central filters Internal and external cleaning (After each wash) You must ensure that the seals around the door, the Inspect the central filters (B) and (C) and remove any detergent and rinse aid dispensers are cleaned regu- scraps of food with a brush, under running water.
  • Page 13: Prolonged Periods Of Non-Operation

    Prolonged Periods of Non-Operation If you are not using the machine for any period of time you are advised to: unplug the appliance and turn off the water; fill the rinse aid dispenser; leave the door ajar to prevent the formation of unpleasant smells;...
  • Page 14: Servicing

    The water supply has been cut off. The inlet hose is kinked. If, after the above checks, the fault persists, call your local Zanussi Service Centre. Please make sure you The water inlet hose filter is clogged. give the model and serial number of the appliance.
  • Page 16 Printed in Italy 0/0897 152995 48/0...

Table of Contents