Adjusting Trim Angle (Power Trim And Tilt) - Yamaha F25 Owner's Manual
Hide thumbs
Also See for F25:
- Owner's manual (122 pages) ,
- Service manual (43 pages) ,
- User manual (25 pages)
Table of Contents
Advertisement
Operation
gle.
1.
Stop the engine.
2.
Tilt the outboard motor up and remove
the trim rod by pressing clip.
1
1. Trim rod
3.
Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod to-
ward the transom.
60
1
ZMU06566
ZMU06536
ZMU06535
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
TIP:
The outboard motor trim angle can be
changed approximately 4 degrees by shifting
the trim rod one hole.
EMU27885
Adjusting trim angle (Power trim and
tilt)
EWM00753
WARNING
Be sure all people are clear of the out-
G
board motor when adjusting the trim
angle. Body parts can be crushed be-
tween the motor and the clamp bracket
when the motor is trimmed or tilted.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
If equipped with a power trim and tilt
G
switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
- Quick Links:
- Engine Oil Requirements
- Changing Engine Oil
Hide quick links:
Advertisement
Table of Contents
