Performing A Pre-Installation Configuration; Pre-Installation Configuration Setup - Cisco Aironet 2600 Getting Started Manual
Hide thumbs
Also See for Aironet 2600:
- Datasheet (7 pages) ,
- Deployment manual (65 pages) ,
- Getting started manual (27 pages)
Table of Contents
Advertisement
Performing a Pre-Installation Configuration
The following procedures ensure that your access point installation and initial operation go as
expected. A pre-installation configuration is also known as priming the access point. This procedure
is optional.
Performing a pre-installation configuration is an optional procedure. If your network
Note
controller is properly configured, you can install your access point in its final location and
connect it to the network from there. See the
Network" section on page 15
Pre-Installation Configuration Setup
The pre-installation configuration setup is shown in
Figure 4
Pre-Installation Configuration Setup
To perform pre-installation configuration, perform the following steps:
12
for details.
Figure
Controller
Layer 3
devices
Cisco Aironet
access points
"Deploying the Access Point on the Wireless
4.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
