Table of Contents
Advertisement
Cisco Catalyst 9130AX Series Access Points
8
Performing a Pre-Installation Configuration
The following procedures ensure that your access point installation and initial operation go as expected. This procedure
is optional.
Note
Performing a pre-installation configuration is an optional procedure. If your network controller is properly
configured, you can install your access point in its final location and connect it to the network from there.
See the
" Deploying the Access Point on the Wireless N etwork" section on page 29
The pre-installation configuration setup is illustrated in
Figure 15
Pre-Installation Configuration Setup
To perform pre-installation configuration, perform the following steps:
Step 1
M ake sure that the Cisco Wireless Controller DS port is connected to the network. Use the procedure for CLI
or web-browser interface as described in the appropriate Cisco Wireless Controller guide.
a. M ake sure that access points have Layer 3 connectivity to the Cisco Wireless Controller M anagement and
AP-M anager Interface.
b. Configure the switch to which your access point is to attach. See the Cisco W ireless Controller Configuration
G uide for the release you are using, for additional information.
c. Set the Cisco Wireless Controller as the master so that new access points always join with it.
Figure
15.
24
for details.
Hide quick links:
Advertisement
Table of Contents
