Cisco Catalyst 9130AX Series Access Points
W arning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 20A. Statement 1005
W arning
Installation of the equipment must comply w ith local and national electrical codes. Statement 1074
W arning
In order to comply w ith FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 12 inches (30 cm) or more from the body of all persons. Statement 332
W arning
Ultimate disposal of this product should be handled according to all national law s and regulations.
Statement 1040
W arning
This equipment is suitable for use in environment air spaces (plenums) in accordance w ith Section
300.22 (C) of the N ational Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian
Electrical Code, Part 1, CSA C22.2. External pow er supply, pow er adapter and/or pow er injector, if
provided, are not suitable for installation in air spaces. Statement 440
4
Unpacking
To unpack the access point, follow these steps:
Step 1
Unpack and remove the access point and the accessory kit from the shipping box.
Step 2
Return any packing material to the shipping container and save it for future use.
Step 3
Verify that you have received the items listed below. If any item is missing or damaged, contact your Cisco
representative or reseller for instructions.
The access point
—
(Optional) Mounting bracket (AIR-AP-BRACKET-1= (default) or AIR-AP-BRACKET-2=, only if selected when
—
you order the access point)
Adjustable ceiling-rail clip (AIR-AP-T-RAIL-R or AIR-AP-T-RAIL-F) (selected when you order the access point)
—
The following accessories can be ordered separately from Cisco:
•
Antenna bracket AIR-AP-BRACKET-9= to mount the C9130AXE directly to the back of the C-AN T9103=
antenna
•
AIR-AP-BRACKET-1= for ceiling mount installations
•
AIR-AP-BRACKET-2= for wall or electrical box installations
•
M id-span power injector AIR-PWRIN J6= when PoE is not available
8