Download Print this page

Preparing The Access Point; Installation Summary - Cisco Aironet 2600 Getting Started Manual

Hide thumbs Also See for Aironet 2600:

Table of Contents

Preparing the Access Point

Before you mount and deploy your access point, we recommend that you perform a site survey (or use

the site planning tool) to determine the best location to install your access point.

You should have the following information about your wireless network available:

• Access point locations.

• Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a

desktop.

You can mount the access point above a suspended ceiling but you must purchase

Note

additional mounting hardware: See

additional information.

• Access point power options: power supplied by the recommended external power supply (Cisco

AIR-PWR-B), a DC power supply, PoE from a network device, or a PoE power injector/hub

(usually located in a wiring closet).

Access points mounted in a building's environmental airspace must be powered using PoE

Note

to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the

device MAC addresses from each location and return them to the person who is planning or managing

your wireless network.

Installing the access point involves these operations:

• Performing a pre-installation configuration (optional)

• Mounting the access point

• Grounding the access point

• Deploying the access point on the wireless network

"Mounting the Access Point" section on page 15

for

Table of Contents

Show Quick Links

Table of Contents