Advertisement
8. Synchronization
Press the SYNC
key on the front panel or 00 DOWN
from the handhel&
A counterclockwise
move-
ment
is
performed
to
synchronize
the
control
unit
with
the
drive
unit
for
proper
operation_
Synchronization
takes
slightly
over one minute,.
After severe
storms,
or an extended
period
of use, the rotator
may appear
to position
the antenna
incorrectly°
First try pressing
the SYNC
key to re-synchronize
the system,
If this fails, the antenna
or
drive
motor
may be misaligned
on the mast. You may either' go to the antenna
and re-orient
it, or
reprogram
the control
unit to correspond
to the new antenna
orientation,
9. Auto Synchronization
The unit may be set to program
a sync command
automatically
after 50 preprograrnmed
moves. This
feature
is switched
on (or reset to 50) by pressing
98 UP. It is switched
off by pressing
98 DOWN.
Check
to see if active
by pressing
99 UP (Display
Status)
and observing
"SYn on" or "SYn
OFF".
10. Timeout
The unit may be set to switch
off after 8 minutes
of no activity
by pressing
97 UP, This feature
is
deactivated
by pressing
97 DOWN°
Check
to see if Timeout
is active
by pressing
99 UP (Display
Status)
and observing
"to on" or "to OFF". The unit automatically
switches
off 5 seconds
after it is
initially
plugged
in or after a power
glitch.
Using the controller
with a "Universal
Remote
Control"
Universal
handheld
remote
controls are popular
as they can typically control a TV, a VCR,
a cable box
and audio components.
They are also cheap
and ideal replacements
for lost and broken
units. The
rotator
controller
will respond
to commands
from universal
remote
controls configured
to control most
Pioneer ® brand cable converter
boxes (HH1 mode) or most
Pioneer _ brand CD players
(HH2 mode).
See Appendix
A.. Refer to the instructions
supplied
with the universal
remote
control. Note: Channel
Master
cannot
guarantee
universal
handheld
remote
control
compatibility,
Front Panel
Setup
Summary
SET 60 Hz POWER
A + _'
SET 50 Hz POWER
,A + _" + SY
SET REMOTE
HH1
,& + SY
SET
REMOTE
HH2
T + SY
AT POWER
UP
AT POWER
UP
AT POWER
UP
AT POWER
UP
Example:
To set for 60 Hz power:
a. Disconnect
the power
connector
at the rear of the unit.
b, Press
and hold UP and DOWN
in together.
c. Reconnect
the power
connector
at the rear end of the unit,.
dr Release
UP and DOWN
Other
functions
are set in a similar
manner
using the following
buttons
at b and d:
50 Hz POWER:
UP, DOWN,
and SYNC
Remote
handheld
! (supplied
unit and most
Pioneer ® cable
boxes):
UP and SYNC
Remote
handheld
2 (most
Pioneer
® CD players):
DOWN
and SYNC
Check
settings
are correct
by removing
power
for a few seconds,
then reconnect
power,.
Display
will indicate:
60H
(or 50H for 50 Hz)
HH1 (or HH2 for alternate
remote)
Advertisement
