Controller
Installation
and Setup
Important
Note!
Before
disconnecting
old control
box, make
note
of each
wire color and the corresponding
terminal
connection.
Caution
- To reduce
the risk of electric
shock,
do not remove
cover.
No user-serviceable
parts
inside.
Refer
servicing
to qualified
service
personnel.
1. Determine
the AC supply
voltage
and frequency
in your' country.
The
US, Canada,
Japan,
Taiwan
and South
America
are generally
117 VAC 60 Hz.. Europe,
Africa,
Australia
and Asia (except
above
mentioned)
are generally
230 VAC 50 Hz.Your
power
company
will advise., Ensure
the supplied
wall
plug power
supply
voltage
has the same
input
voltage
as your
household
supply
(+10%).
If not,
contact
your dealer,.
2.. Plug the power
supply
into the controller
and the household
supply,
Observe
the digital
diagnostic
display° It should
display:
60H (or 50H in 50 Hz countries)
HH1 (to use with the supplied
handheld
remote
control)
If the above
are not correct
refer' to Appendix
A to change.
3. Disconnect
the walt plug supply
at the wall outlet.. Connect
the cables
between
the controller
and
drive
unit.
if
C'-
[
Mod_!95_7 i
Strip Ends 1/2" F -Black
_--_,svAc ® _
_
[:_ J®
l
CAUTION
!
L__jlA.P
j ^
_ _
t
Outer
Sleeving
The
exclamation
point
indicates
the
presence
of
important
operating
and
maintenance
(servicing)
instructions
in the
literature
accompanying
the
appliance.
Terminals
Connections
Green Wire #1 to #1
Black Wire #2 to #2
Red Wire #3 to #3
4_ Reconnect
the AC supply to the controller.
After 5 seconds
it will switch off. Switch
back on by pressing
any key on the front panel or handheld
remote
control.
Perform a synchronization
by pressing
the sync
button on the front panel. This takes slightly
over one minute° The unit may now be operated
from the
front panel using the up and down controls.
5. Digital
Compass.
This feature
operates
as follows:
The display
is 000 to 360 degrees
where
000 is North
(fully CCW
viewed
by a bird)
090 is East
180 is South
270 is West
360 is North
(fully CW viewed
by a bird)