Enabling The Persistent Fc Id Feature; Persistent Fc Id Configuration Guidelines; Configuring Persistent Fc Ids - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual
Cli software configuration guide
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Command reference manual (792 pages)
Table of Contents
Advertisement
Enabling the Persistent FC ID Feature
Enabling the Persistent FC ID Feature
To enable the persistent FC ID feature, perform this task:
Procedure
Step 1
Step 2
Step 3
Persistent FC ID Configuration Guidelines
When the persistent FC ID feature is enabled, you can enter the persistent FC ID submode and add static or
dynamic entries in the FC ID database. By default, all added entries are static. Persistent FC IDs are configured
on a per-VSAN basis.
When manually configuring a persistent FC ID, follow these requirements:
• Ensure that the persistent FC ID feature is enabled in the required VSAN.
• Ensure that the required VSAN is an active VSAN. Persistent FC IDs can only be configured on active
• Verify that the domain part of the FC ID is the same as the runtime domain ID in the required VSAN.
• Verify that the port field of the FC ID is 0 (zero) when configuring an area.
Configuring Persistent FC IDs
To configure persistent FC IDs, perform this task:
Procedure
Step 1
Step 2
Step 3
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
492
Command or Action
switch# configuration terminal
switch(config)# fcdomain fcid persistent
vsan vsan-id
switch(config)# no fcdomain fcid persistent
vsan vsan-id
VSANs.
If the software detects a domain mismatch, the command is rejected.
Command or Action
switch# configuration terminal
switch(config)# fcdomain fcid
database
switch(config-fcid-db)# vsan vsan-id
wwn 33:e8:00:05:30:00:16:df fcid fcid
Configuring Domain Parameters
Purpose
Enters configuration mode.
Activates (default) persistency of FC IDs in
the specified VSAN.
Disables the FC ID persistency feature in the
specified VSAN.
Purpose
Enters configuration mode.
Enters FC ID database configuration submode.
Configures a device WWN (33:e8:00:05:30:00:16:df)
with the FC ID 0x070128 in the specified VSAN.
To avoid assigning a duplicate FC ID, use the
Note
show fcdomain address-allocation vsan
command to display the FC IDs in use.
OL-16597-01
Advertisement
Chapters
Table of Contents
Troubleshooting
