Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 512
Cli software configuration guide
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Command reference manual (792 pages)
Table of Contents
Advertisement
Reason Codes
Reason Code (long version)
Offline
Inactive
Hardware failure
Error disabled
Isolation because limit of active
port channels is exceeded.
Isolation due to ELP failure
Isolation due to ESC failure
Isolation due to domain overlap
Isolation due to domain ID
assignment failure
Isolation due to the other side of
the link E port isolated
Isolation due to invalid fabric
reconfiguration
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
466
Description
The switch software waits for the
specified R_A_TOV time before
retrying initialization.
The interface VSAN is deleted or
is in a suspended state.
To make the interface operational,
assign that port to a configured and
active VSAN.
A hardware failure is detected.
Error conditions require
administrative attention. Interfaces
may be error-disabled for various
reasons. For example:
• Configuration failure.
• Incompatible buffer-to-buffer
credit configuration.
To make the interface operational,
you must first fix the error
conditions causing this state and
then administratively shut down or
enable the interface.
The interface is isolated because
the switch is already configured
with the maximum number of
active SAN port channels.
The port negotiation failed.
The port negotiation failed.
The Fibre Channel domains
(fcdomain) overlap.
The assigned domain ID is not
valid.
The E port at the other end of the
link is isolated.
The port is isolated due to fabric
reconfiguration.
Configuring Fibre Channel Interfaces
Applicable Modes
Only E ports and TE ports
OL-16597-01
Advertisement
Chapters
Table of Contents
Troubleshooting
