Link-Level Flow Control; Priority Flow Control - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual
Cli software configuration guide
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Command reference manual (792 pages)
Table of Contents
Advertisement
Information About QoS
• Type qos—A type qos policy is used to classify traffic that is based on various Layer 2, Layer 3, and
Link-Level Flow Control
IEEE 802.3x link-level flow control allows a congested receiver to communicate a transmitter at the other
end of the link to pause its data transmission for a short period of time. The link-level flow control feature
applies to all the traffic on the link.
The transmit and receive directions are separately configurable. By default, link-level flow control is disabled
for both directions.
On the Cisco Nexus 5000 Series switch, Ethernet interfaces do not automatically detect the link-level flow
control capability. You must configure the capability explicitly on the Ethernet interfaces.
On each Ethernet interface, the switch can enable either priority flow control or link-level flow control (but
not both).
Priority Flow Control
Priority flow control (PFC) allows you to apply pause functionality to specific classes of traffic on a link
instead of all the traffic on the link. PFC applies pause functionality based on the IEEE 802.1p CoS value.
When the switch enables PFC, it communicates to the adapter which CoS values to apply the pause.
OL-16597-01
Layer 4 fields in the frame and to map it to system classes.
Some configuration parameters when applied to an EtherChannel are not reflected on
Note
the configuration of the member ports.
◦ Classification—The traffic that matches this class are as follows:
◦ Access Control Lists—Classifies traffic based on the criteria in existing ACLs.
◦ Class of Service—Matches traffic based on the CoS field in the frame header.
◦ DSCP—Classifies traffic based on the Differentiated Services Code Point (DSCP) value in
the DiffServ field of the IP header.
◦ IP Real Time Protocol—Classifies traffic on the port numbers used by real-time applications.
◦ Precedence—Classifies traffic based on the precedence value in the type of service (ToS)
field of the IP header.
◦ Protocol—Classifies traffic based on the protocol field of the IP header.
◦ Policy—The actions that are performed on the matching traffic are as follows:
This policy can be attached to the system or to any interface. It applies to input traffic
Note
only.
◦ QoS Group—Sets the qos-group corresponding to the system class this traffic flow is mapped
to.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Link-Level Flow Control
425
Advertisement
Chapters
Table of Contents
Troubleshooting
