Manually Configuring The System Priority - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual
Cli software configuration guide
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Command reference manual (792 pages)
Table of Contents
Advertisement
Manually Configuring the System Priority
Step 4
Step 5
This example shows how to configure a vPC domain MAC address:
switch# configure terminal
switch(config)# vpc domain 5
switch(config-if)# system-mac 23fb.4ab5.4c4e
Manually Configuring the System Priority
When you create a vPC domain, the system automatically creates a vPC system priority. However, you can
also manually configure a system priority for the vPC domain.
Note
We recommend that you manually configure the vPC system priority when you are running LACP to
ensure that the vPC peer switches are the primary switches on LACP. When you manually configure the
system priority, ensure that you configure the same priority value on both vPC peer switches. If these
values do not match, vPC will not come up.
Before You Begin
Ensure that you have enabled the vPC feature.
You must configure both switches on either side of the vPC peer link with the following procedure.
Procedure
Step 1
Step 2
Step 3
Step 4
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
142
Command or Action
switch# show vpc role
switch# copy running-config
startup-config
Command or Action
switch# configure terminal
switch(config)# vpc domain
domain-id
switch(config-vpc-domain)#
system-priority priority
switch# show vpc brief
Purpose
(Optional)
Displays the vPC system MAC address.
(Optional)
Copies the running configuration to the startup
configuration.
Purpose
Enters configuration mode.
Selects an existing vPC domain on the switch, or creates
a new vPC domain, and enters the vpc-domain
configuration mode. There is no default domain-id ; the
range is from 1 to 1000.
Enters the system priority that you want for the specified
vPC domain. The range of values is from 1 to 65535. The
default value is 32667.
(Optional)
Displays information about each vPC, including
information about the vPC peer link.
Configuring vPCs
OL-16597-01
Advertisement
Chapters
Table of Contents
Troubleshooting
