Manually Configuring Controller Information Using The Access Point Cli; Connecting To The Console Serial Port - Cisco AIR-BR1310G-A-K9 - Aironet 1310 Outdoor Access Point/Bridge Hardware Installation Manual
Wireless outdoor access point/bridge
Hide thumbs
Also See for AIR-BR1310G-A-K9 - Aironet 1310 Outdoor Access Point/Bridge:
- Datasheet (15 pages) ,
- Hardware installation manual (146 pages)
Table of Contents
Advertisement
Manually Configuring Controller Information Using the Access Point CLI
Manually Configuring Controller Information Using the Access
Point CLI
In a new installation, when your access point is unable to reach a DHCP server, you can manually
configure needed controller information using the lightweight access point CLI.
The CLI commands in this section can be used only on a lightweight access point that is not associated
Note
to a controller.
The static information configured with the CLI commands are used by the lightweight access point to
connect with a controller. After connecting with the controller, the controller reconfigures the access
point with new controller settings, but the static IP addresses for the access point and the default gateway
are not changed.
Connecting to the Console Serial Port
If you need to configure the access point locally (without connecting to a wired LAN), you can connect
a PC to the power injector console serial port using a DB-9 to RJ-45 serial cable. Follow these steps to
open the CLI by connecting to the console serial port:
Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial port on the power injector and
Step 1
to the COM port on your PC.
Figure 5-3
1
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
5-6
Figure 5-3
Console Serial Port Connector
Console serial port connector (RJ-45 connector)
Chapter 5
shows the power injector's console serial port connector.
1
Troubleshooting Lightweight Access Points
OL-5048-06
Advertisement
Table of Contents
