Table of Contents
Advertisement
Configuring the Date, Time, and Time Zone
Configuring the Date, Time, and Time Zone
Setting the Date
Cisco Content Services Switch Getting Started Guide
2-16
For example, to configure a static IP route to destination network address
192.168.0.0 /16 and a next hop address of 192.168.1.1, enter:
(config)# ip route 192.168.0.0 /16 192.168.1.1
For example, to configure a default IP route using a destination address of
0.0.0.0/0 and a next hop address of 192.167.1.1, enter:
(config)# ip route 0.0.0.0 /0 192.167.1.1
Refer to the Cisco Content Services Switch Routing and Bridging Configuration
Guide for complete information on configuring IP routes.
To set the date, time, or time zone for the CSS, use the clock command. When you
enter this command, the CSS displays the current date and time.
The clock command does not allow backspacing. If you enter the wrong date,
time, or time zone, you must reenter the command with the new information.
This section includes the following topics:
Setting the Date
•
Setting the European Date
•
Setting the Time
•
Setting the Time Zone
•
•
Showing the Date and Time
Use the clock date command to set the date. A prompt appears to show the current
date in the correct format to use. Enter the month, day, and year as integers with
dash characters separating them. For example, enter June 15th 2003 as 06-15-03.
Enter the new date in the format mm-dd-yy as shown:
# clock date
Enter date: [12-31-03] 12-31-03
Chapter 2
Configuring CSS Basics
OL-6037-01
Hide quick links:
Advertisement
Table of Contents
