Table of Contents
Advertisement
Configuring the Ethernet Management Port
Configuring a Default Gateway for the Ethernet Management Port
Cisco Content Services Switch Getting Started Guide
2-12
The rip redistribute static and ospf redistribute static commands do not
•
advertise static routes configured on the Ethernet management port. These
two commands only advertise static routes configured on the Ethernet
interface ports.
Use the ip management route command to configure static routes for the
Ethernet management port. This command is available in global configuration
mode.
The syntax for the ip management route command is:
ip management route ip_address subnet_mask ip_address2
The variables are as follows:
ip_address - The destination network address. Enter the IP address in
•
dotted-decimal notation (for example, 192.168.11.0).
subnet_mask - The IP subnet mask. Enter the mask as either:
•
A prefix length in classless interdomain routing (CIDR) bit-count notation
–
(for example, /24).
An IP address in dotted-decimal notation (for example, 255.255.255.0).
–
ip_address2 - The next hop address for the route. Enter the IP address in
•
dotted-decimal notation (for example, 192.168.11.0).
For example, to configure a static route for the Ethernet management port, enter:
(config)# ip management route 172.27.59.0 /24 172.27.56.86
To disable a static route for the Ethernet management port, enter:
(config)# no ip management route 172.27.59.0 /24 172.27.56.86
The Ethernet management port allows you to boot the CSS from the Offline DM
menu when the boot image resides on a different subnet. Use the gateway address
command to configure a default gateway for the Ethernet management port. This
command is available in boot mode.
To specify a default gateway for the Ethernet management port for use in Offline
DM, enter:
(config)# boot
(config-boot)# gateway address 172.16.57.2
Chapter 2
Configuring CSS Basics
OL-6037-01
Hide quick links:
Advertisement
Table of Contents
