Installing A Css 11503 As A Rackmounted Unit; Figure 1-2 Front-Mounting The Mounting Brackets On The Css 11503 - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual
11500 series content services switch
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Configuration manual (432 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Chapter 1
Unpacking and Installing the CSS
Installing a CSS 11503 as a Rackmounted Unit
Figure 1-2
Front-Mounting the Mounting Brackets on the CSS 11503
1
2
78-13884-06
Before you rack-mount the CSS 11503:
Determine if you want to front-mount or mid-mount the mounting brackets
•
on the CSS chassis. Refer to the location of the mounting bars in the
equipment cabinet to determine the mount position of the mounting brackets.
•
Install the mounting brackets on the CSS, as described below.
Before you begin, you need the mounting brackets and the eight Phillips screws
shipped in the accessory kit accompanying the CSS 11503, and a #1 Phillips
screwdriver.
To install the mounting brackets on the CSS chassis:
1.
Position the CSS with its front panel facing you. On the left and right sides
of its chassis, note the screw holes for installing the mounting brackets.
2.
Position a mounting bracket on one side of the chassis. Align it with the
appropriate screw holes for front- or mid-mounting.
Figure 1-2
illustrates front-mounting the mounting brackets.
illustrates mid-mounting of the brackets.
MAN AGE MEN
T
10B ASE -T
LINK /ACT
DUP LEX
STAT US
GE 1
1
LINK
2
3
4
GE 2
LINK
5
6
7
8
9
10
11
12
13
PCM CIA
SLO T 1
3
SLO T 0
CON SOL E
LINK
DPL X
LINK
DPL X
Cisco 11500 Series Content Services Switch Hardware Installation Guide
C IS C O 11
50 0
C O N T E
SER IES
N T
S E R V I C
E S
S W I T C
H
14
15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
LINK
DPL X
LINK
DPL X
Installing the CSS 11503
Figure 1-3
1-15
Advertisement
Table of Contents
Troubleshooting
