Table of Contents
Advertisement
Chapter 1
Unpacking and Installing the CSS
Installing the CSS 11050 or CSS 11150 as a Free-Standing Unit
Rack-Mounting the CSS 11050 or CSS 11150
Installing the Mounting Brackets
78-15146-02
Position the CSS 11050 or CSS 11150 on the selected flat surface. When
installing the CSS, note that all cables connect to the front of the unit with the
exception of the cable that connects to the Ethernet management port on the rear
panel and the power cord.
Before you rack-mount the CSS 11050 or CSS 11150:
Determine if you want to front-mount or mid-mount the CSS chassis into the
•
cabinet. The difference between front-mount or mid-mount is:
Front-mount sets the front edge of the unit even with the front edge of the
–
rack
Mid-mounting the CSS sets the front edge of the unit past the front edge
–
of the rack
Install the mounting brackets on the CSS. The rack position of the CSS
•
determines where you will install the mounting brackets on the CSS chassis.
See the following section to install the mounting brackets.
Before you begin, you will need the mounting brackets and eight screws shipped
in the accessory kit accompanying the CSS 11050 and CSS 11150, and a #2
Phillips screwdriver.
To install the mounting brackets on the CSS chassis:
Position the CSS with its front panel facing you. On the left and right side of
1.
its chassis, note the screw holes for installing the mounting brackets.
Position a bracket on one side of the chassis. Align the bracket with the
2.
appropriate screw holes for front- or mid-mounting.
Figure 1-2
illustrates front-mounting the brackets.
mid-mounting the brackets.
Cisco 11000 Series Content Services Switch Hardware Installation Guide
Installing the CSS 11050 or CSS 11150
Figure 1-3
illustrates
1-7
Advertisement
Table of Contents
Troubleshooting
