Power Guidelines For Dc Systems (Css 11503 And Css 11506); Required Tools And Equipment - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual
11500 series content services switch
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Configuration manual (432 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Chapter 1
Unpacking and Installing the CSS
Power Guidelines for DC Systems (CSS 11503 and CSS 11506)
Warning
Required Tools and Equipment
78-13884-06
The DC-input power supply allows the CSS 11503 and CSS 11506 to operate at
–48 VDC nominal in North America and at –48 VDC or –60 VDC in Europe.
See
Table 1-2
for system power specifications, including input voltage and
operating frequency ranges.
Incorporate a readily accessible 2-poled disconnect device into the fixed
wiring.
Follow your local and national electrical codes for DC wiring.
To install the CSS hardware, you need the following tools and equipment:
•
A #1 Phillips-head screwdriver
An anti-static wrist strap, provided in the CSS accessory kit
•
A hand lift (recommended) for lifting the CSS chassis into the equipment
•
rack
Once you complete the installation, you need a console terminal (or equivalent)
that runs at 9600 baud to enter console commands (refer to
Troubleshooting the
CSS).
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Required Tools and Equipment
Chapter 2, Cabling and
1-7
Advertisement
Table of Contents
Troubleshooting
