Rack-Mount And Cable-Management Kit; Equipment Required To Verify Your Plant's Rf Setup - Cisco 7246 - uBR Router Hardware Installation Manual
Universal broadband router
Hide thumbs
Also See for 7246 - uBR Router:
- Configuring (28 pages) ,
- User manual (7 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Chapter 2
Preparing the Cisco uBR7200 Series Router for Installation
•
•
•
•
•
Rack-Mount and Cable-Management Kit
The rack-mount and cable-management kit includes the following parts:
•
•
•
•
•
You must install the cable-management bracket on the right side of the Cisco uBR7246 or Cisco
Note
uBR7246VXR chassis, when viewed from the front. If the cable-management bracket is installed on the
left side of the chassis, where the internal fans are located, you will not be able to easily remove or
replace the fan tray. If you install your Cisco uBR7246 or Cisco uBR7246VXR router, with the
rack-mount brackets at the front of the chassis, you cannot install a cable-management bracket.
For more information on the rack-mount brackets and cable-management brackets, refer to the
"Cisco uBR7200 Series Chassis Rack-Mounting Options" section on page
Equipment Required to Verify Your Plant's RF Setup
To verify your plant's RF setup, you need the following:
•
•
•
•
•
OL-5421-03
2
12 AWG (4 mm
) cable with a minimum of three conductors rated for at least 140
DC-input power supply installations only)
Standard wire stripper (for DC-input power supply installations only)
Tape (for securing the handle of a DC circuit breaker in the OFF position when a DC-input power
supply is powered down)
Tape measure (optional)
Level (optional)
Two rack-mount brackets for mounting the chassis in the rack.
One cable-management bracket to relieve the strain on installed port adapter and cable interface line
card interface cables.
Eight M4 x 6-mm Phillips flathead screws to secure the rack-mount brackets to the chassis.
Four M3 x 6-mm Phillips panhead screws to secure the cable-management bracket to the chassis.
Four 10/32 x 3/8-inch slotted binderhead screws to secure the rack-mount brackets to the rack rails.
IF-to-RF upconverter
RF spectrum analyzer
For coaxial cabling:
Diplex filters/splitters
–
Coaxial cable crimping tool
–
New coaxial cable
–
Coaxial jumpers that are at least 2 to 3 feet long (maximum of 5 feet)
–
For fiber networks, optical receivers for each upstream optical path
Assorted RF attenuators (with at least two 20-dB attenuators)
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
Rack-Mount and Cable-Management Kit
o
o
F (60
C) (for
3-2.
2-9
Advertisement
Table of Contents
Troubleshooting
