Figure 1-1 Software Version For The Css - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Chapter 1
Managing the CSS Software
CSS Software Overview
CSS Software Overview
The CSS software contains the files needed to run the CSS, including boot files,
directories for archiving and logging files, and MIB files. This software is
pre-installed on the CSS conventional hard disk or on an optional Flash disk,
which is a Flash memory-based storage device. The CSS software is
approximately 50 MB, and you can install a maximum of two software versions.
The CSS software image is available from the Cisco Systems website
(www.cisco.com) as an ArrowPoint Distribution Image (ADI), network boot ZIP
(.zip) image, or GZIP-compressed (adi-gz) image.
You can install the CSS software on an FTP server, which the CSS accesses
through the File Transfer Protocol (FTP). The CSS accesses the ADI or GZIP file
containing the CSS software from an FTP server, copies the file to the CSS disk,
and unpacks it. The CSS then boots from the disk.
You can also install the CSS software on a network-mounted drive on a remote
system, which the CSS accesses through FTP. Network boot uses a special ZIP
version of WebNS that ends with a .zip extension. Instead of the CSS disk, the
network file system contains the CSS software. This software must be copied and
uncompressed on the network drive.
Refer to
Chapter 2, Specifying the CSS Boot
Configuration, for information on
booting the CSS, including from a network boot drive.
The CSS software version format is shown in
Figure
1-1.
Figure 1-1
Software Version for the CSS
sg 00 00
0
00
Build number
Maintenance version
Minor version
Feature version
Major version
Build prefix
To display the software versions installed on the CSS, use the show version and
show installed-software commands, as described in the
"Showing Software
Information"
section.
Cisco Content Services Switch Administration Guide
1-2
OL-5647-02
Advertisement
Table of Contents
